User Manual
KH 310 | 9
The acoustical axis of the KH 310 starts from the midpoint of the mid range and tweeter dri-
vers.
X
Always point the acoustical axis, in the horizontal and vertical planes, towards the listening
position.
The acoustical axis is a line perpendicular to the loudspeaker’s front panel along which
the microphone was placed when tuning the loudspeaker’s crossover during design.
Pointing the acoustical axis, in the horizontal and vertical planes, towards the listening
position or center of the monitoring area will give the best measured and perceived
sound quality.
X
Position the loudspeaker so that there is a direct line of sight from the listening position to
the bass, midrange and tweeter drivers.
Connecting the audio cables
Connecting analog cables
X
Connect the output sockets of your audio source to the XLR input sockets of the loudspea-
kers.
XLR
XLR
Signal B
Signal A
Analog Source
X
Use an RCA-XLR adapter (not supplied) to connect unbalanced cables (e.g. RCA cables).
X
Use the following wiring if you want to make your own RCA-XLR adapter:
Wiring Pin Signal
Source (RCA)
Source (RCA)
Loudspeaker (XLR-M)
Loudspeaker (XLR-M)
1 Audio ground
2 Signal +
3 Signal −
x = 9.1 cm
y = 17.0 cm
Connecting
XLRcables
Connecting
unbalanced cables
EN