Operation Manual

NX-595E User Manual 51
Troubleshooting
• NX-595E may not work on corporate network due to firewalls, proxy servers,
and other security settings. Connect it to a network port that can provide
direct access to the internet.
• Check that other devices on the same network can connect to the internet, if
they are working then confirm all access codes are correct (serial number,
Web Access Passcode, username, PIN)
System Status Messages
Zone Number / Zone Name
In alarm – This zone has triggered a system alarm condition
Is bypassed – This zone is isolated (disabled) and will not activate an alarm
Chime is set – This zone is part of the chime group
Is not secure – This zone is not closed
Fire alarm – This zone has triggered a fire alarm
Tamper – This zone has triggered a tamper alarm
Trouble fault – This zone has an open circuit
Loss of wireless supervision – This zone is a wireless device and has lost its communication link
with the control panel
Low battery – This zone is a wireless device and needs its battery changed
Partition Number / Partition Name
Is on in the away mode – This partition is armed in the away mode
Is on in the stay mode – This partition is armed in the stay mode
Is ready – This partition is secure and ready to be armed
Is not ready – This partition is NOT ready to be armed, a zone is not secure
All partitions are on in the away mode – All partitions in this multi partition system are armed in
the away mode
All partitions are on in the stay mode – All partitions in this multi partition system are armed in the
stay mode
All partitions are ready – All partitions in this multi partition system are secure and ready to be
armed