Operation Manual

14 NX-595E User Manual
Main Menu Explained
System Status
Press [1] to hear the current status of the security system. Please refer to table
on page 53 & 54 for a complete list of system status messages.
System Control
Press [2] to access the System Control menu, this menu allows easy everyday
operation of the security system, from arming and disarming individual or multi
partition systems to bypassing (isolating / excluding) individual zones as
required. The internal 185 event log is also accessed from this menu.
 - Security System Status – Refer to the status message table.
 - Partition Control – This is where partitions are armed / disarmed (turned
on / off) from either the away or stay modes
 - To Control Zone Bypass – This is where zone/s are isolated (disabled)
and removed from the security systems arming cycle
 - Event History – This is where the last alarm can be viewed, or the last
512 events, which are stored in the panel’s internal log
 - To move back to the main menu
Output Control
Your security system is supplied with two outputs, and can be configured to
control up to a total of 16 outputs. These outputs can be used for a variety of
applications, such as Intercom door release, external lighting control, electric
shutter control or even garage door control. As additional equipment is required
to enable these features, please contact your service provider for further details.
Speak with your security provider to discuss possible applications for your
installation.
 - Select an output number followed by hash – Allows a user to select
individual outputs to control
 - For output list – Informs a user of available outputs for selection.
 - To move back to the main menu
Message Bank
Press [4] to access the message bank. Separate 10 second entry and exit
messages can be recorded, and will be played back to the user who arms (turns
on) and disarms (turns off) the security system.
 - Exit message – A 10 second message that will be played after arming
the security system