Operation Manual

12 NX-595E User Manual
Phone Line connection, and network connection
• All of the above features plus:
• Email Reporting – Up to three email addresses can be entered.
• DHCP - or Dynamic Host Configuration Protocol, is a computer network
protocol used by devices to obtain configuration information for operation in
an Internet Protocol network. This protocol reduces system administration
workload, allowing networks to add devices with little or no manual
intervention
• NX-595E Web Interface – Once connected to the network, users will enjoy
the simple web user interface that is supplied with the NX-595E. Enter the IP
address of your NX-595E into a web browser to access the NX-595E
Configuration Server. Here the user can configure pin codes, arm and disarm
partitions, view the last 185 event history, enter and change all voice and
divert phone numbers and assign email address. Installers have further
access to network settings, feature lists and outputs.
• Relays – The two onboard relays are fully configurable and come defaulted
for door release one and door release two.
Accessing the NX-595E via a Touch Tone
Phone
This section describes how to access the NX-595E via an off-site touch-tone
phone. The NX-595E must be on an independent line to the touch-tone phone
from which you are trying to connect. The NX-595E must be pre-programmed by
your security service provider to automatically answer the incoming call once the
predetermined number of calls/rings have been reached. When the desired
number of calls / rings has been reached the NX-595E will grab the phone line
and announce the following.
 Enter your code for system access, press star to cancel
Enter your user / master code (default master code is 1234), the NX-595E will
announce the recorded system name (if recorded) and list all accessible main
menus, you can now make your selection as required.
 You are now connected to (system name)……
Press 1 for system status
Press 2 for system control
Press 3 for intercom control
Press 4 for output control
Press 5 for message bank
Press 0 for system configuration *
Press # to exit and disconnect the session
* Denotes master code access only
The above sequence will be shown throughout this manual as
[PIN].