Manualshelf

Installation Instructions

ManualsBrandsNetworX ManualsBackupNX-595E IP Communication Module
27282930313233343536
© 2015 UTC Fire & Security Americas Corporation, Inc. All rights reserved. 33
operation. For security reasons it is recommended this option be disabled.
Option 5: Enable NTP Server Time Updates: The NX-595E will check its internal clock and
use the internet to compare it against GMT time. This is done every 15min and will update itself
if the variance is greater than 3 minutes.
Option 6: When enabled an installer will automatically have access to Feature Setup, Network
settings, Output settings and IP reporting via the NX-595E's web pages. Otherwise the NX-
595E will need to be in program mode to access these additional features. By default this is on.
Option 7: Enable DLX900 Server: Allows remote configuration using DLX900 software.
Disable to prevent DLX900 connections to the NX-595E. Enabled by default and for the first 5
minutes after power up. Note this option does not prevent DLX900 connections to the panel via
PSTN, disable this in panel programming if required.
Option 8: Enable Web Access: When enabled, email and IP reporting will function. If the Web
Access Passcode is set to a non-zero value, email and IP reporting will function.
Segment 2: Reserved
Location 20 - IP Gateway
The 4 segments in Location 20 are used to view or set the IP address of the network gateway. If
you have disabled DHCP, you must manually set the IP address of the NX-595E
In homes, the gateway is usually the Internet Service Provider (ISP) device that connects the
user to the internet, such as a DSL or cable modem.
In an enterprise system, the gateway is the node that routes the traffic from a workstation to
another network segment. The default gateway is commonly the node connecting the internal
networks and the outside network (Internet).
Segments 1 - 4
Location 21 - NX-595E IP Address
The 4 segments in Location 21 are used to view or set the IP address of the NX-595E.
Segments 1 - 4
Location 22 - Subnet Mask
The 4 segments in Location 22 are used to view or set the Subnet mask.
Segments 1 - 4
Location 23 - DNS Server 1
The 4 segments in Location 23 are used to view or set the networks DNS server address.
Segments 1 - 4
Location 24 - DNS Server 2
The 4 segments in Location 24 are used to view or set the networks DNS server address.
Segments 1 - 4
Location 25 - Reserved
Segments 1 - 4
Location 26 - Reserved
Segments 1 - 4