Installation Instructions

26 © 2015 UTC Fire & Security Americas Corporation, Inc. All rights reserved.
Partition Removal via Panel Programming
Note: NetworX panel default configuration has all zones assigned to
partition 1. The result of this default configuration is the GUI and UltraSync
application displays all of these zones to the end user, even if they are not
installed in the panel. It is recommended practice to “remove” unused
zones from the NetworX panel. This is accomplished by removing the
partition assignment from all unused zones. To accomplish this task, you
will have to access the panel via the keypad. Deselect partition 1 for zones
that are not installed in the panel. Access device 0, Location 26-36 (even
locations only) to accomplish this task. See the table below for more
information.
Zone Partition Assignment
Device
Zones
Location
Segment
Action
0
1-8
26
1-8
Deselect all partitions from each
segment if zone is not installed in the panel
9-16
28
1-8
17-24
30
1-8
25-32
32
1-8
33-40
34
1-8
41-48
36
1-8
Example, Zone 26 would be programmed with Location 32, Segment 2.
Configuring the NX-595E with the UltraSync application
The configuration procedure with the UltraSync application is identical to the
procedure described above for a web browser. Follow the instructions below to
install and configure the UltraSync application.