Installation Instructions

14 © 2015 UTC Fire & Security Americas Corporation, Inc. All rights reserved.
Enrolling, Defaulting and Retrieving the IP
Address for the NX-595E
The NX-595E is automatically set to device address 191 and programming is
carried out like all other NetworX modules.
Default the NX-595E following these instructions depending on the type of keypad
you are using. When you exit program mode, the NX-595E will be automatically
enrolled.
Using a NX-181xx Voice keypad
Step
1.
[MENU]-[0]
Selects main menu - Option 0, Advanced system
configuration

Enter your code, touch menu to exit.
2.
[?]-[?]-[?]-[?]
Enter your 4 or 6 digit Programming code

Touch 1 for keypad configuration
Touch 2 for panel and device configuration
Touch 3 to configure service provider phone
number
Touch menu to exit.
3.
[ 2 ]
Selects Panel and Device configuration

Select a device number followed by enter
Touch menu to go back.
4.
[ 1 ][ 9 ][ 1 ]
[ENTER]
Connects to device 191 (NX-595E)

Selected device 191 is connected.
Select a Location number followed by enter
Touch menu to go back.
5.
[ 9 ][ 1 ][ 0 ]
[ENTER]
Defaults the device, Note: only required once
6.
[2][1]
[Enter]
This keypad will announce the first number of the IP
address
7.
[MENU]
This keypad will announce the second number of the
IP address
8.
[MENU]
This keypad will announce the third number of the IP
address
9.
[MENU]
This keypad will announce the fourth number of the IP
address
10..
[MENU]
Moves back to step 4, select a device number
11.
[MENU]
Moves back to step 3, Advanced system configuration
selection.
12.
[MENU]
Exits from Advanced system configuration. (exiting
program mode automatically enrolls the NX-595E)