Installation Instructions

10 © 2015 UTC Fire & Security Americas Corporation, Inc. All rights reserved.
Introduction
The NX-595E is an IP communication module that can be added to a NetworX V2
family security product (NX-4, NX-6, NX-8, NX-8E) to provide remote access and
alarm reporting via standard Internet connections (IP). The NX-595E can utilize two
connection methods to your central monitoring station. It can connect directly to an
Osborne Hoffman (OH) NetRec receiver. Alternatively, it can use UltraSync
services. Contact your central monitoring station to determine their preferred
connection method.
The security panel can be configured for alarm reporting exclusively over IP when
PSTN connectivity is no longer available. Alternatively, it can utilize the PSTN for
failover connectivity in the event the IP communications path is lost.
The NX-595E provides a web browser interface accessible via a local computer,
smart phone or tablet to configure the device. Additionally, UltraSync™, an Apple
®
iOS
®
or Android
®
application, is available for remote configuration and end user
control of the security system including control of two output relays. Up to four
zones are also supported with zone doubling (not available on NX-4 panels). Three
email addresses can be programmed into the NX-595E to allow alarm and trouble
events to be emailed to the end user.
This manual assumes the installer is familiar with the NetworX V2 family of security
products and is capable of programing the security system. It also assumes that the
installer is familiar with basic computer networking and Apple iOS or Android smart
devices.
Setup is a simple process:
1. Install the NX-595E into the NetworX panel.
2. Enroll the NX-595E into the NetworX panel.
3. Minimum configuration is required:
a. Time and daylight savings setup (Feature Menu)
b. IP Reporting (IP Reporting Menu)
c. Enable remote UltraSync application support by setting the Web Access
Passcode (Network Settings Menu)
Important notes before proceeding
The PINs for accessing the NX-595E are stored in the NetworX panel. Make
sure you are using the existing PIN for the Installer when configuring the NX-
595E.
Record the following information in the UltraSync Quick Reference Guide during
the installation process:
NX-595E serial number (12-digits)
Web Access Passcode (8- numerical digits)