Operation Manual

LISTEN-IN ICON
Listen-in icon is on when an NX-534E audio module is active in listen-in mode.
POWER ICON
The power icon is on if the mains power is on. It will be off if there is no mains. The power icon will flash if the
System has a low battery condition.
READY ICON
The ready icon is “on” when the system is ready to arm and “flashes” if ready to force arm.
NOT READY ICON
The not ready icon is on when the system is not ready to arm because of a zone(s) being faulted.
ALARM ICON
The alarm icon is flashing when an alarm has occurred.
SILENCED ICON
The silenced icon appears after a code has been entered to silence the siren but the zone has not been
cleared.
TAMPER ICON
The tamper icon is on when a zone(s) is tampered. Press [r]–[2] and refer to the Service Menu section of this
manual for further instructions.
SERVICE ICON
The service icon is on when a tamper occurs or when the system requires service. Press [r]–[2] and refer to the
Service Menu section of this manual for further instructions.
TROUBLE ICON
The trouble icon is on when a dayzone(s) are faulted or when there is a trouble in the system.
ENTER CODE ICON
The enter code icon is on whenever a valid code should be entered on the keypad.
1.. 48 ZONE ICON
The zone icons are “off” when everything is normal. A zone icon will be “on” if the zone has been bypassed. If
a zone icon is “flashing”, that zone is in alarm or has been faulted. If a zone icon is “flashing” rapidly, it means
that the zone is in a trouble condition.
NX-1348E-ICON User manual Page 8 23/07/05