Operation Manual

Group bypass
By pressing the [BYPASS] key, followed by the [0] key, then the [BYPASS] key again, all zones that are designated as
group bypass zones will be bypassed. Press the [BYPASS] key again -or- press the [#] key to exit group bypassing.
Unbypassing zones
To manually unbypass zones, perform the bypassing procedure on a zone that is already bypassed. The
corresponding icon for that zone will go off when unbypassed. NOTE: All zones will automatically be unbypassed
each time the system is disarmed.
Turning the door chime ON and OFF
The door chime is turned on or off by pressing the [CHIME] key while the system is in the disarmed state. If the
chime is on the chime led will be illuminated. If the chime is off, the chime led will be off. Each press of the [CHIME]
key will toggle the chime feature on/off and produce a momentary ding-dong sound.
ADDING AND CHANGING USER CODES
Your system must be Disarmed to change user codes.
Step 1 Press [r]-[5]
Step 2 The Enter Code icon will display. Enter a [“Master Arm/Disarm” Code].
N For partitioned systems, someone changing the code of another person must have access to all or
more partitions than the user being changed.
Step 3 The Ready led will flash.
Step 4 Enter the 2-digit “user number”.
(Always enter 2 digits such as [0]-[3] for user 3.)
Step 5 The instant icon will flash and zone icons will illuminate specifying the first digit of the “user code”.
 When all icons are all illuminated = code is blank; when all icons are off = “0”.
 Use the [•] and [–] keys to view the next digit or enter new 4- or 6-digit “user code”.
 While using the [•] and [–] keys, you can change any digit by entering a new digit. This will advance you
to the next digit.
To delete a user code, enter [r]-[r]-[r]-[r] for a 4-digit code, or [r]-[r]-[r]-[r]-[r]-[r] for a 6-digit code.
Step 6 The ready led will flash indicating you are back at Step 2 above. If the code is rejected, the sounder will
beep 3 times.
Step 7 If another “user code” needs to be programmed, return to Step 4.
Step 8 Press the [#] key while the ready led is flashing to exit the User Code Programming Mode.
NX-1348E-ICON User manual Page 12 23/07/05