Operation Manual

OTHER KEYPAD FUNCTIONS
Setting the keypad tone
Step 1 Press the [r] key.
Step 2 Press the [0] key. Keypad is now in the “Adjust Tone” mode.
Step 3 Pressing the [1] key will make the keypad sounder go to higher tones, pressing the [2] key will
make the keypad sounder go to lower tones.
Step 4 When the desired tone is reached, press the [#] key to set this tone and exit
from the “Adjust Tone” mode.
View alarm memory
Step 1 Press the [r] key.
Step 2 Press the [3] key to display the zone(s) on the keypad that created the last alarm.
Step 3 The ALARM MEMORY feature will flash those zones that created alarms and will light steady those
zones that were bypassed during the last alarm.
Test function (optional)
If programmed, this function will perform a battery test, communicator test, and/or a siren test.
Step 1 Press [r] [4] [4]. The test will be performed as programmed.
Step 2 If the siren test is performed, enter a user code to silence the siren.
No alarms will be sent and no reports will be sent unless a communicator test is performed, at which time a
test signal will be sent.
Detector reset function
This function is used to reset Smoke Detectors and Zone Troubles. Your system must be Disarmed to use the Reset
function.
Step 1 Press [r]-[7]. Resets have now been performed. The FIRE light will go off if the smoke detectors
have been reset.
Step 2 If the keypad begins beeping, the reset did not execute properly. Enter your code to silence the
keypad. Wait a few minutes and repeat step 2 to attempt another reset. If the keypad still beeps
after repeated attempts, please contact your installer.
NX-1208E-ICON User manual Page 14 16/04/05