Operation Manual

ADDING AND CHANGING USER CODES
Your system must be Disarmed to add/change user codes.
Step 1 Press [r]-[5].
Step 2 Enter a “Master Arm/Disarm Code”.
NOTE: For partitioned systems, someone changing the code of another person must have
access to all or more partitions than the user being changed.
Step 3 The ready light will flash.
Step 4 Enter the 2 digit (applies to NX4/6/8) or 3 digit (applies to NX8E) “user number” (always enter 2 digit
such as [0] - [3] for user 3, or [1] - [0] - [0] for user 100).
Step 5 Enter the new four (4) or six (6) digit “user code”.
NOTE: To delete a user code, enter [r]-[r]-[r]-[r] for a 4-digit code, or [r]-[r]-[r]-[r]-[r]-[r] for
a 6-digit code.
Step 6 The ready light will flash indicating you are back at Step 4 above. If the code is rejected, the
sounder will beep 3 times.
Step 7 If another “user code” needs to be programmed, return to Step 5.
Step 8 Press the [#] key while the ready light is flashing to exit the User Code Programming Mode.
ASSIGNING USER CODE AUTHORITY LEVELS
Assign authority levels to users by following the steps below. Assign user codes before assigning authority levels.
Your system must be in the disarmed state to change user code authority levels.
Step 1 Press [r]-[6]-[“Master Arm/Disarm Code”].
NOTE: Someone changing the authority of another person can only add or remove partition
authorization for partitions to which they have access.
Step 3 The ready light will flash.
Step 4 Enter the 2-digit (applies to NX4/6/8) or 3-digit (applies to NX8E) user number. Always use leading
zeros when necessary, i.e. "004" for user number 4. The ready light is constant and the instant light
will flash.
NX-1208E-ICON User manual Page 12 16/04/05