Operation Manual

CANCEL / ABORT feature (optional)
The abort light will flash during an abort delay time. If a code is entered while this light is flashing, all abortable
reports will stop the communication process. Entering a code during or after an alarm report to the central station
will cause the abort light to come on. It will stay on until the central station has received the cancel report.
Bypassing zones
If you wish to bypass one or more zones, this must be done while the system is in the disarmed state. The
following steps are used for bypassing zones:
Step 1 Press the [BYPASS] key.
Step 2 Enter user code, if required (optional). The bypass light flashes.
Step 3 Enter 1 or 2 digits indicating the zone you wish to bypass. (Example: Press the [1] key for zone 1, press [1] -
[2] for zone 12.)
Step 4 Press the
[BYPASS] key again.
Step 5 The corresponding zone light will illuminate indicating the zone has been bypassed. Repeat steps 3 and 4
for any other zone(s) that need to be bypassed.
Step 6 Press the
[BYPASS] key again -or- press the [#] key to exit the Bypass Mode. The bypass light will
stop flashing upon exiting the Bypass Mode.
Group bypass
By pressing the [BYPASS] key, followed by the [0] key, then the [BYPASS] key again, all zones that are
designated as group bypass zones will be bypassed. Press the
[BYPASS] key again to exit group bypassing.
Unbypassing
To manually unbypass zones, perform the bypassing procedure on a zone that is already bypassed. The
corresponding light for that zone will go off when unbypassed.
NOTE: All zones will automatically be unbypassed each time the system is disarmed.
Turning the door chime ON and OFF
The door chime is turned on or off by pressing [r]-[1] while the system is in the disarmed state. If the chime is “on”,
the chime light will be illuminated. If the chime is “off”, the chime light will be off. Each time [r]-[1] is pressed it will
toggle the chime feature on/off and produce a momentary ding-dong sound.
NX-1208E-ICON User manual Page 11 16/04/05