Instructions

4. Part Setting using Part Set Codes
Ensure that all m onitored areas are secured. Enter your
passcode, the exit sounder will m ake a continuous tone. If
required leave via the norm al exit route and close the final exit
door, (pressing the Exit Term inator button if fitted). The system is
part set when the exit sounder stops, the display will alternate
between the group/area which has been arm ed and the current
time.
5. Setting with Circuits Omitted
It may som etim es be desirable to om it a circuit when full or part
setting the system .
1. Enter your passcode (users 1-9) and press [ within 5
seconds.
2. Press 7 and the display will show the circuit num ber
followed by its om it status. N = not om itted and Y =
om itted.
3. Press 0 to change the status of the circuit and [ to confirm
the change. A low tone will indicate that the circuit cannot
be om itted or a high pitch multi-tone indicates that the
change has been accepted. Continue with the next circuit
if required.
4. Press ] to quit to "user m enu 1" and continue with setting by
pressing 0 for full-set or A or B or C for part-set (see 2 and
3).
6. Silent Setting
The system can be full set or part set silently except for the final
system set sound. Enter your passcode (users 1-9 ) and for full set
press 8 within 5 seconds. For part set press A or B or C then
press 8 .
Alternatively
Enter your passcode (users 1-9) and press [ within 5 seconds.
Press 8 and the display will show SIL -. Enter 0 for silent full set
or A or B or C for silent part set.
7. Setting and Unsetting With a Keyswitch
Operate the keyswitch (or door lock) and leave via the exit route.
The system will be full set or part set when the exit sounder stops.
To unset the system , operate the keyswitch (or lock) again.
3
TS700 LED User Operating Instructions
00
.
15
User passcode B entered.
Group/area B will set in 15
seconds.
B
SET
Group/area B is now arm ed.
1 -
‘User m enu 1’ selected.
01-N
Circuit 01 will not be om itted.
01-Y
Press 0 to change the status.
Circuit 01 will now be om itted.
SIL-
Press [0] for silent full set or [A] or
[B] or [C] for silent part set.
1 -
"User m enu 1" selected.