User Manual
Table Of Contents
7
flash and alert according to the time that event triggered.
Ex2. If the level of alarm triggered at the same time is high (one of the three), then the priority
level of alarm trigger is low (doorbell), then the lower one will not cover other alarm because
the priority level of doorbell is low, and the alarm will flash and alarm according to the higher
one.
No matter what kind of alarm status, when Z602A receives command to stop alarming, it will
stop generating sounds.
Except the 4 alarms mentioned above, Z602A would not generate sounds toward any other
alarms e.g. malfunctioning alert, it would only flash the light.
According to different alarm types, the flashing method will be different, such as Doorbell and
malfunctioning alert are on & off flashing alternately (blink), and the rest are flowing light.
Z602A alarm preset time is 240 seconds (Range: 5~65535).
Under the security status, when the door sensor is triggered, the burglar alarm will be generated.
Under the disarmed status, if the door sensor is triggered, and the doorbell sound be generated.
4.5.2 IAS of alarm and the hint of alarm light flashing
When the security system is set as disarm, Z602A would beep twice, and flash twice.
When the security system is set as arm, Z602A would beep once, and flash once.
When the security system is set as arm, the two indicators
*1
would turn on.
When the security system is set as disarm, the two indicators would turn off.
*1
Two indicators: Alarm indicator 2 and 5 of product appearance picture.