Tus neeg siv phau ntawv

9
6. Installation
This product comes with waterproof function.
When using it, the back of it can be adsorbed on the iron surface, or the two ends can be fixed to the wall with screws.
1. The Wireless 2-Gang Temperature Sensor (R718B2) has a
built-in magnet (see Figure 1 below). When installed, it can
be attached to the surface of an object with iron which is
convenient and quick.
To make the installation more secure, use screws (purchased)
to secure the unit to a wall or other surface (see Figure 2
below).
Note:
Do not install the device in a metal shielded box or in an
environment with other electrical equipment around it to
avoid affecting the wireless transmission of the device.
R718B2 is suitable below scenarios:
Oven
Industrial control equipment
Semiconductor industry
2. When R718B2 is compared with the last reported
values, the temperature change is exceeded 0.1°C
(default),it will report values at the MinTime interval;
If does not exceeded 0.1°C (default) ,it will report values
at the MaxTime interval;
Temperature probe
Note:
Please do not disassemble the device unless it is required to replace the batteries.
Do not touch the waterproof gasket, LED indicator light, function keys when replacing the batteries. Please use suitable
screwdriver to tighten the screws (if using an electric screwdriver, it is recommended to set the torque as 4kgf) to ensure the
device is impermeable.