User Manual

4.2 WAN/LAN Connection

The network source connects to the RJ-45 port (WAN/LAN). The network source supports static IP

and DHCP client. If user needs an external IP Camera, please connect it to another router on the

same network segment

4.3 Power on

Plug in the 5V/1.5A transformer to boot

4.4 Reboot

In the power-on state, press the reset button at the bottom to restart R207C

*If press the button for more than five seconds, it will restore to the factory setting.

4.5 Indicator

Cloud indicator:

Keep On: Connected to the cloud

Flash: Not connected to the cloud

4.6 Restore to Factory Setting

In the power-on state, press and hold the reset button for 5 seconds and release to restore the factory

setting.

5. Set up R207C

5.1 Connect to the device

Please connect the network source to the RJ-45 (WAN/LAN) jack of R207C and connect to the

power supply. The router of the network source needs to enable DHCP to view the DHCP List.