User's Manual

5-2. Join the ZigBee Network

After ZB02C is turned on, it will search for an existing ZigBee network and send a request to join the network

automatically. While ZB02C is under the coverage from a coordinator or a router whose permit-join feature

is enabled, ZB02C will be permitted to join the network.

Step1. Enable the permit-join function (valid for 60 seconds) of a coordinator or a router (please refer to

the user manual of the coordinator or the router to enable the permit-join feature).

Step2. Turn on ZB02C. It will start to search and join the network.

Step3. The indicator will flash 5 times after it is joined successfully. Otherwise, the indicator will not

flash.

ZB02C will try to join the network for 1 minute. Please try step1~3 again when it is failed to join the network.

5-3. Binding

ZB02C can be bound with the On/Off device such as Netvox Z801RX.

Step1. Press and hold the Binding Key for 3 seconds. The indicator will flash orange once.

Step2. Release the Binding Key and then press the Binding Key N times (N = the number of the button)

within 5 seconds. For example, press the Binding Key 3 times when you would like to bind Button 3.

The indicator will flash N times.

Step3. Enable the binding feature of the On/Off device.

Step4. The indicator flashes 5 times after the binding is completed; otherwise, it will flash 10 times.

5-4. Sleeping Mode

ZB02C is designed to go into sleeping mode for power-saving in some situations:

A. While the device is in the network → the sleeping period is 5 minutes; it will wake up every 5

minutes to keep online.

B. When it doesn’t find a network to join → ZB02C will go to sleeping mode. It will wake up every 15

minutes to search a network to join.

C. Once ZB02C was joined to a network and by any chance the network is no longer existed or the

device is out of the network → ZB02C will wake up every 15 minutes to find the network it joined

before.

It never keeps in sleeping mode and continues to find out a network every 15 minutes. This condition would

consume up to 30 times power spending compared to normal-operating status. To prevent this unwanted power

consumption, we recommend that users remove the batteries to power off the device.