User's Manual
8
y The text format and the password both are correct, but it is unsuccessful to arm/disarm the
system → Z602B will send a failed-to-setup message to the users, and the Status Indicator
would flash 3 times.
y Users send the text message with wrong password for 3 times → Z602B will send a
wrong-password message to the users, and the SMS feature will be disabled until users reboot
Z602B.
When the storage for SMS is full, Z602B will delete all the saved messages automatically. The Status
Indicator will flash twice when all the messages are deleted.
For more detailed settings of GSM feature, please refer to the 7. ZiG-BUTLER
section.
5.7. HeartBeat Technique
In a security system, it is important for devices to report the conditions to the central security unit (the CIE
device). To meet this need, Netvox came up with a technique called “HeartBeat”.
Right after Z602B enrolls to a security system, it sends a HeartBeat signal to the CIE device. Afterward, it
will send HeartBeat data every hour by default settings.
5.8. Battery
y After Z602B joins a network, it checks the battery status every 10-minute.
y Under the circumstance that the DC 12V is plugged, it will be recharged for 16 hours when battery
voltage is between 1.8V and 3.6V. While recharging, the Alarm/Status Indicator will stay ON. After fully
charged, the Alarm/Status Indicator will be OFF.
y Under the circumstance that the DC 12V is unplugged, the Alarm/Status Indicator will flash 20 times
when the operating voltage is between 2.8V and 3.6V. Z602B will also send a low-power report to the
CIE device.
y Users can only use AAA Ni-MH rechargeable batteries for Z602B.
5.9. Restore to Factory Setting
While Z602B is unable to communicate with its enrolled CIE device or users would like Z602B to join a new
network, a factory reset is required. To restore it to factory setting, please follow the steps:
Step1. Power off Z602B.
Step2. Press and hold the Setting Key, and then power on Z602B.
Step3. After Z602B generate 2 doorbell sounds and the indicator shows fast flashes, release the button to
complete the restore.
After the factory restore, reboot Z602B to initiate it.