User's Manual

Assigning Z311C to a preferred CIE system
This feature is only available for user who has the relevant application software or
Netvox ZiG-BULTER to do this. Please go to ZiG-BUTLER
section in this manual.
Z311C can be paired with a CIE system device (i.e. Z201B). When a change in security
status Z311C notifies bound CIE to trigger audible alarm or light strobe signal to notify the
user.
Observation:
(1) In the case that you are assigning Z311C to its already-registered CIE security
system, Z311C simply displays 6 red flashed on its LED indicator when reassignment
configuration is completed.
(2) In the case that you are assigning Z311C to a different CIE security system other
than the one registered, after new registration successfully took place Z311C sends
deregistering command to the already-registered CIE security system to remove its
Z311C’s information. The indicator shows 6 red flashes upon configuration completed.
For programmer and application developer only:
When doing so, changes of the CIE device IEEE address in the IAS_CIE_Address
attribute written in Z311C will take place. A new CIE IEEE address will be assigned to
and will be written on Z311C device. You will need software similar to ZiG-BUTLER to
perform this configuration.