User's Manual
- 7 -
Z1 0 0 E
Z
i
g
Bee Pro
TM
- RF M odule
* When EMBER USB_Link is inserted into the USB port on the PC, the driver will
automatically installed and the USB device port can be found.
* EMBER USB_Link does not serve as power supply to the RF module under test,
please make sure the power is given before burning the firmware.
II. Install programming software
On the PC, select and double click on the executable NZpp_Setup icon to install then
follow the prompt to complete the installation.
III. Burning a firmware
When done. A short cut is then created for you on your desktop as shown in the figure
bellow:
Double click on the icon to run the programmer’s software