Installation Guide

（Picture III）
Item
Description
1
Internet Port: Standard RJ45 port ， 10/100M Adaptive ， suggest use CAT5 or CAT5E
line.
2
Power Adaptor：12V/1A input，left port is “+”，right port is “-”
3、5
Door Exit Switch：To connect indoor exit button
4、6
External Switch/Door Lock：To connect door lock, alarm etc.
7
Wiegand Port: To connect wiegand card reader.
8、9
Door sensor detection：to detect the door open/close status.
10
To mix device voice & remote call voice, then release them together. 1 port is for
record, another port is for GND.
12
Audio Input: To connect a external audio signal.
13
JP1 jumper（Picture II）
14
JP6 jumper（Picture II）
JP1, JP6 Jumper
Door lock control include 2 models (default is internal power supply), see as below,
Internal power supply: If electric lock starting current less than 500mA/12V, can use internal drive model,
electric lock port is 12V DC output.
(Picture IV）
Wiring Description
NO: Normal Open, working status electric lock is
open；
COM: Common port；
NC: