User's Manual

10
WIFI configuration is on page of user control center.
Select an online camera. Then select your wanted wifi in the list of discovered
wireless signal, and enter its password. Click Connect button to access.
If the below prompt appears, it means that the wifi is being configured.
User can close this window after several seconds. Then remove the network
cable and repower the camera.
If your WIFI configuring information is correct, please disconnect the network cable and restart
the camera. If the camera in the left list is not in green in 3minutes, an error may have occurred on
configuring WIFI. Please reconfigure WIFI.
If it appears the prompt Obtaining firmware/Wifi information has timed out, please
check whether your network is in normal condition.
(Note: In the first time of configuring wifi, please ensure that the camera has been in normal
network condition by network cable. Only after the success of WiFi connection, can you remove
the network cable and use the camera anywhere within the WiFi signal)