User Guide
Table Of Contents
- Driver Installation...
- Printing Issue........
- Platform Setup.......
- MAC Driver
- Windows Driver
- Printing Issue
- (1)Q: why my labels are not sharp / dark?
- (3)Q:Why I printed many blank labels?
- (4)Q: Why the position of the print content is offset
- (5)Q: Why the printer is skipping labels or continuou
- (6)Q: Why the printer print extra blank labels after
- (7)Q: Why the label is getting stuck or half-printed?
- (8)Q: Why the printer’s button is flashing?
- (9)Q: Why my label is printing sideways?
- Platform Setup
- Shopify Setup
- eBay Setup
- UPS WorldShip
- Etsy Setup
- Amazon.com Customer Orders Setup
- Tips and Tricks
- How to create new customized label size
- How to print label in nonstandard 4x6 inch size, s
19
(7) Q: Why the label is getting stuck or half-printed?
A. NT-LP110A prints by heating the print head.
If the label is stuck (generally appears in very dark things like bar codes or thick straight lines), it is
most likely because you set a too high print density for the label.
This would cause the label to become too hot and stick on the print head. This is because various tags
react differently to the same heat.
You can set the print speed to "4" and the density to "2", and then try printing again. If your label is too
shallow now, increase the density by 1. If the effect is not satisfactory, you can debug step by step.
How to adjust On PC:
Control Panel > Devices and Printers > Right click on NT-LP110A > Printer Preferences > Page
Setup
Adjust Speed / Density and click on OK.