User Manual

- 2 -
3. LED and Beeper Indication
Successful Scan
Buzzer
LED
Yes
One beep
Light On then OFF
Failed
Three beeps
Light flash once then OFF
Continuous beeps
Light OFF
Important Note:
When scanner make continuous beeps please configure the channel
for it. Refer to 'Configure Working Channel'.
Barcode Programming
Our barcode scanners are factory programmed for common
terminal and communications settings. If you need to change these
settings, programming is accomplished by scanning the bar codes in
this guide. An asterisk (*) next to an option indicates the default
setting.
Communication Mode
USB -KBW *
When you connect the scanner to the Host via a USB connection,
you can enable the USB-KBW feature by scanning the barcode below. It
works on a Plug and Play basis and no driver is required.
USB -KBW *