Quick Setup Guide

Firmware Version:
Firmware version will be displayed by scanning “$SW#VER”.
Barcode Programming
$SW#VER
Netum barcode scanners are factory programmed for the most common
terminal and communications settings. If you need to change these settings,
programming is accomplished by scanning the bar codes in this guide. An
asterisk (*) next to an opt ion indicates the default setting.
Important Notes :
Many command barcodes only work with scanner in a particular connection
mode. Please pay attention to below symbol when you scanning the command
barcodes.
Command barcodes only apply to scanner work via Bluetooth connection.
Command bacodes only apply to scanner work via Wirel ess Conn ection.
Co mma nd b aco des o nl y ap ply to s can ner wor k vi a US B Wi red Con nec tion
Connection Way
Scanner can be connected to your device via bluetooth, USB rece iver or USB
cable, you can choose one of the connection way to connect scanner with
your device.
Working Via USB Cable
Get Started: Connect scanner with your device via USB cable. If you use US
keyboard, it's plug and play. If you use other type of keyboard , please refer to
"keyboard language" to con௭igure the keyboard language before you use it.
I
I
I
W
(2)