User manual

Safety
5
2 Safety
General areas of application of the PKL are for knocking off adhesive bulk
materials from container walls (e.g. silos, hoppers, filter outlets, pipelines
and reactors) and for emptying residues from weighing containers. The
PKL also prevent bridging and rat-holing, so that the material can continu-
ously flow.
The PKL can be used outdoors and in dusty environments, however not in
water or any other liquids.
PKL may only be operated with a timed on/off sequence.
Any other use is considered improper.
Installation, commissioning, maintenance and troubleshooting of the PKL
may only be performed by authorised qualified personnel
All handling of the PKL is the responsibility of the operator.
IMPORTANT
NetterVibration
assumes no liability for personal injuries and material
damages if technical changes to the product were made or the notices and
regulations in these operating instructions were not observed.
DANGER
Falling parts
The PKL
, construction parts as well as fastening and locking
screws can come loose due to vibration. Falling parts lead to
severe personal injuries.
 Use only Netter fastening kits (NBS) to fasten the PKL.

The PKL 190, PKL 450 and PKL 740 are open on the
side of impaction. During installation ensure that the im-
pact piston remains in the housing.
 Mount the PKL 2100, PKL 5000 and PKL 10000 addi-
tionally with an impact plate and two damper rings
(flange and impact plate) or with an EE kit and a damper
ring (flange).
 Check the fastening and locking screws after one hour of
operation and thereafter at regular intervals (generally
monthly).
 Retighten the fastening and locking screws, if necessary.
 A safety device with a safety cable is mandatory for criti-
cal mounting situations.
Intended use
Qualification
of qualified
personnel
Liability
Falling parts