Datasheet

ManualsBrandsNETTER VIBRATION ManualsPneumatics AccessoriesVibrator PKL 740/6 C 6 bar

Serving industry with vibration

•

Higher impact power than traditional impactors

•

Lower compressed air requirement per impact

•

Lownoise versions with elastomer insert EE

•

Versions with automatic control ST

•

ATEX or stainless steel versions available

Netter Pneumatic Impactors

Series PKL

PKL 450

PKL 740 PKL 2100

Summary of content (4 pages)

PAGE 1
27 • • • • • Serving industry with vibration Netter Pneumatic Impactors Series PKL Higher impact power than traditional impactors Lower compressed air requirement per impact Low noise versions with elastomer insert EE Versions with automatic control ST ATEX or stainless steel versions available PKL 450 PKL 740 PKL 2100
PAGE 2
Netter Pneumatic Impactors Series PKL qóéÉ= PKL 190/4 Weághí çÑ piston xâÖz= MINV= cçêÅÉ çÑ iãpactG= xâÖz= MIQP= léíáãìã=oéÉê~íáåÖ pêÉëëìêÉ= xÄ~êz= QIM= Air consumption/impact ~í=oéíáãìã=pêÉëëìêÉ= xkçêã~ääáíÉêz= MI2M lvÉr~lä= wÉáÖÜí= xâÖz= MIU= pìáí~ÄäÉ=Ñçê=w~ää= tÜáÅâåÉëë=of xããz= N=Ó=O= PKL 190/6 MINV= MISM= SIM= MI20 MIU= N=Ó=O= mhi=QRMLQ= MIQQ= MIRS= QIM= MI40 NIS= N=Ó=P= mhi=QRMLS= MIQQ= MIVO= SIM= MI60 NIS= N=Ó=P= mhi=TQMLP= MITQ= NIPM= PIM= MI50 OIS= O=Ó=Q= mhi=TQM
PAGE 3
Netter Pneumatic Impactors Series PKL ST Kit Applications The ST kit enables a continuous impact sequence when connected to a permanent compressed air supply. Impact Frequency The impact frequency can be adjusted by means of a throttle valve installed in the air supply line. The maximum impact sequence must be observed. EE Kit Applications The EE kit is used to produce a low noise impact or "rubber hammer effect".
PAGE 4
Netter Pneumatic Impactors Series PKL Sound protection hoods Applications The use of hoods is particularly worthwhile for bunkers with insulation covers. Attaching the sound protection hood to the insulation cover fully insulates the source of the noise (bunker). Vacuum Fixing Devices VAC Applications Series VAC vacuum fixing devices serve the fast fixation of impactors on smooth or, under certain circumstances, rough or curved surfaces. They allow quick and simple attachment without welding or screwing.