Instructions

11
5 Transport and storage
DANGER
IMPORTANT
Packaging
The devices are packed ready for
installation. The identification mark is on
the impactor.
Accessories and attachments are supplied
separately unless otherwise agreed.
Special transport conditions are not
stipulated.
With new devices the piston may stick
because of the paint. Turn the piston
slightly to release.
The packaging protects the compressed air
piston vibrators against transport damage.
The packaging materials have been
selected according to criteria of
environmental compatibility and ease of
disposal and are therefore recyclable.
Returning the packaging to the materials
cycle saves raw materials and reduces the
level of waste.
Storage
Storage should be in a dry, clean
environment. Equipment with steel housing
must be oiled on being placed back into
storage (feed machine oil into air intake
and outlet and move piston in and out by
hand while turning a few times).
It can be stored at a temperature of
between -10 °C and +25 °C. (This does
not apply to the operating temperature).
For transporting the vibrators NTK 85 and
NTK
110 suitable lifting gear must
be
used.
For
lifting a transport lug can be
screwed
into
the piston or the housing (thread
M
20).
Lifting
and lowering is to be
started
carefully
as the piston moves in and out
of
the housing.
Take care when lifting and lowering!
Check the packaging for any damage in transit.
In the event of damage to the packaging, inspect the contents for completeness
and any damage. In the event of damage, inform the carrier.