User Manual

AirMagnet Enterprise Sensor 4 Series SmartEdge Sensor
18
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance
20cm between the radiator & your body.
This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
The availability of some specific channels and/or operational frequency bands are
country dependent and are firmware programmed at the factory to match the intended
destination. The firmware setting is not accessible by the end user.
Sensor4 with Embedded type antenna and maximum antenna gain is 4.8 dBi in 5 GHz
and 2.0 dBi in 2.4 GHz.
Industry Canada Statement
This device complies with RSS-210 of the Industry Canada Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
IC Radiation Exposure Statement
This equipment complies with IC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance
20cm between the radiator and your body.
Industry Canada Interference Statement
The device for the band 5150-5250 MHz is only for indoor usage to reduce potential for
harmful interference to co-channel mobile satellite systems;The maximum antenna gain
3.1 dBi permitted (for devices in the bands 5250-5350 MHz and 5470-5725 MHz) to
comply with the EIRP limit.
In addition, users should also be cautioned to take note that high- power radars are
allocated as primary users (meaning they have priority) of the bands 5250-5350 MHz
and 5650-5850 MHz and these radars could cause interference and/or damage to LE-
LAN devices.
Industrie Déclaration de Canada
Cet artifice se plie à RSS-210 de l'Industrie les Règles du Canada. L'opération est
soumise aux deux conditions suivantes : (1) Cet artifice peut ne pas provoquer
l'interférence malfaisante et (2) cet artifice doit accepter n'importe quelle interférence
reçue, en incluant l'interférence qui peut provoquer l'opération indésirable.