User Manual

Installation
7
Antenna Installation
1. Screw on the supplied antennas to the RP-TNC connectors on the
sensor side plates.
2. Position the antenna angles as shown in the following "Antenna Angle
Positioning" section.
3. Hand tighten the antenna to the sensor while maintaining the angles
depicted.
4. Apply a small amount of Loctite or similar adhesive in the antenna
joint (elbow) to maintain antenna angle positioning during and after
sensor installation.
Antenna Angle Positioning
The following images indicate the recommended antenna positions for optimum
performance.
Note: With an antenna installed, as the antenna is rotated, it will click into position at
each 45 degree point in its rotation.