User's Manual

21
Access Right: Select a access right for the corresponding SNMP community
(Deny
7
/Read
8
/Write
9
).
Community: Specify the name of community for the SNMP manager( Private/Public). By
convention, “Public” community is with a read-only access right.
5.4.2 SNMP Trap
Traps can be used by network entities to signal abnormal conditions to management stations.
SNMP TRAP message can be sent to a host. Click APPLY to complete your settings.
Version: Select the SNMP Version.
Select “Disable” to disable the snmp trap function of the corresponding item.
Version1: SNMP Version1
Version2: SNMP Version2
IP Address: Specify the IP Address of the SNMP Manager for SNMP Trap Report.
Community: Specify the name of community ( public/Private) for SNMP manager.
Following are the traps supported in the access point:
Cold-start trap:
This trap indicates that the specified node’s power has just come on. The cold-start trap is
generated every time the access point is power-cycled. Cold-start traps are not generated
until three seconds after the access point is power-cycled. This allows time for the hardware
providing the low-level IP network interface to start up and stabilize before attempting to
send a packet.
7
Deny community will not allow a remote device to read information from a device or to modify settings on that
device.
8
Read-only community enables a remote device to retrieve "read-only" information from a device.
9
Read-Write community allows a remote device to read information from a device and to modify settings on that
device.