User's Manual

1
Chapter 1 Introduction
1.1 Feature
l Fully interoperable with IEEE 802.11b compliant products.
l High-Speed data transfer rate up to 11Mbps.
l 64-bit and 128-bit WEP Encryption.
l MAC Address filtering.
l Web-Based Network Manager/Telnet for Configuring and Managing Your access points.
l SNMP MIB I and MIB II supported.
l Capable of acting as a DHCP Server.
l Remote Management supported.
l Firmware Upgrade via WEB/TFTP
l IEEE802.1x/RADIUS Client (EAP-MD5/TLS/TTLS) Support
1.2 Package Contents
l One CD-ROM with User Guide included
l One Power Adapter
l One CAT 5 UTP Cable
l One Fast Start Guide and One Registration Card
Chapter 2 Hardware Configuration
2.1 Hardware Configuration
1. RJ-45 Ethernet connector
Provides 10/100 Mbps connectivity to a wired Ethernet LAN.
2. Reset Button
By pressing this button for over 3 seconds, the AP will be reset with factory default
configuration.
3. Power Supply connector
It is for connecting to the power adapter.
2.2 Hardware Installation
1. Configure your notebook or PC with Wireless LAN card.
2. For Wired LAN, connect your PCs’ Ethernet port to any AP’s LAN port by an Ethernet cable.
3. For WLAN, locate the AP to a proper position.
4. Plug the power cord into a power outlet.