User Manual

10 Chapter 2: Getting Started
AirMagnet A5205 Sensor User Guide
The tamper-evident seals are required for AirMagnet Sensors operated
in FIFS mode. The following instructions apply only to Sensors that are
intended to comply with the FIPS requirement.
To apply the tamper-evident seals:
1) Tighten each of the retention screws using a screwdriver, making
sure that they are all tight.
2) Clean the areas where the seals are to be applied.
3) Place the seals over the sides of A5205 Sensor, as shown in Figure
2-7.
A5205 Sensor User Guide.book Page 10 Thursday, January 15, 2009 1:46 PM