User Manual

8 Chapter 2: Getting Started
AirMagnet A5205 Sensor User Guide
Figure 2-4: A5205 Sensor Rear Panel
Table 2-2: A5205 Sensor Real Panel Interfaces
Interface Description
Power 12V For supplying power to the Sensor using a DC 12V
universal adapter.
Note: This does not apply when PoE is used.
Reset • Pressing and holding down the button for less
than 5 seconds will reboot the Sensor.
• Pressing and holding down the button for more
than 5 seconds will reset the Sensor to its factory
default settings.
RJ-45 (Lan Port) For connecting the Sensor to an Ethernet
network through an RJ-45 Ethernet cable. The RJ-45
comes with built-in 802.3af PoE compliance.
RS-232 (Serial Port) For troubleshooting the Sensor using the
Hyperterminal.
Power 12V
Reset
RJ-45
RS-232
A5205 Sensor User Guide.book Page 8 Thursday, January 15, 2009 1:46 PM