User Manual

16 Chapter 3: Installing A5200 Sensor
AirMagnet A5200 Sensor User Guide
4) Gently slide the Sensor towards the Locking Plate until it is fully
engaged.
5) Secure the Sensor with padlock.
Powering Up A5200 Sensors
Customers deploying AirMagnet Enterprise can power their
AirMagnet sensors using a standard Ethernet cable, thus avoiding
the need to run the standard electrical wiring to each and every
individual sensor. AirMagnet offers two PoE options, and customers
can typically make their own choice based on the quality of the
switch to which their AirMagnet sensors will be connected.
Powering Up via an 802.3af-Compliant PoE Injector
To power up A5200 Sensor via an 802.3af-compliant PoE Injector:
1) Connect the PoE injector (via the Data Only port) to a network
switch or hub, using a 10/100 Ethernet cable.
2) Connect the PoE injector (via the Power and Data port) to A5200
Sensor using another 10/100 Ethernet cable.
3) Plug the power cord into an electrical outlet. See Figure 3-2.
Figure 3-2: Powering up A5200 via 802.3af-compliant
A5200 Sensor
PoE injector
A5200 Sensor User Guide.book Page 16 Thursday, January 15, 2009 2:00 PM