User Manual
Table Of Contents
- AirMagnet A5200 Sensor User Guide
- Hardware Warranty
- Table of Contents
- Chapter 1: Introduction
- Chapter 2: Getting Started
- Chapter 3: Installing A5200 Sensor
- Appendix A: A5200 Sensor Specifications
- Appednix B: A5200 Standard Antennas
- Index
AirMagnet A5200 Sensor User Guide
Chapter 2: Getting Started 11
Applying Tamper-Evident Seals
The tamper-evident seals are intended to prevent tampering of the
AirMagnet SmartEdge Sensors and help network administrators to
easily identify traces of tampering should it have occurred. To
effectively use the tamper-evident seals, care must be taken to ensure
that the seals are applied properly.
The tamper-evident seals are required for AirMagnet Sensors operated
in FIFS mode. The following instructions apply only to Sensors that are
intended to comply with the FIPS requirement.
To apply the tamper-evident seals:
1) Tighten each of the retention screws using a screwdriver, making
sure that they are all tight.
2) Clean the areas where the seals are to be applied.
3) Place the seals over the sides of A5200 Sensor, as shown in Figure
2-7.
A5200 Sensor User Guide.book Page 11 Thursday, January 15, 2009 2:00 PM