User Manual

15
WDS Setting Click the “Show WDS Setting”
button to configure WDS
settings. The WDS settings pops up.
Enable Universal
Repeater Mode
Mark this checkbox to enable Universal Repeater Mode
which acts this device as an AP and client
simultaneously.
Root AP SSID While you e
nable the Universal Repeater Mode, you
have to specify an SSID for the extended interface.
Click <Apply changes> button at the bottom of the screen to save the above
configurations. You can now configure other advance sections or start using the
AP (with the advance settings in place)
Active Wireless Client Table
This is the window that pops up after clicking the “Show Active Clients”
button.
MAC Address MAC address of this active wireless station.
Tx Packet The number of transmitted packets that are sent out
from this active wireless station.
Rx Packet The number of received packets that are received by
this active wireless station.
TX Rate The transmission rate
Power Saving Shows if the wireless client is in Power Saving mode
Expired Time This is the time in second before dissociation. If the
wireless keeps idle longer than the expired time, this
wireless AP will dissociate it. The wireless client station
has to associate again when it is active.