User's Manual

Wireless 11n 2T2R Router

Wireless Mode

In the drop list, there are two types of wireless mode: “AP” and “Client”.

You may select one type for your configuration.

Note: This fuction only support in AP mode.

SSID

Service set identifier (SSID) for the name of the wireless network. In

Client Mode, this SSID is used for setting Virtual AP's name.

Channel Width

Select 20MHz or 40MHz

(40MHz only support in 11n mode) as the

wireless channel frequency.

Channel Number

Select a channel for the wireless network of this device.

Country

contains USA(FCC), Canada(IC), Europe(ETSI), Spain, France,

Japan(MKK) for your selection.

Broadcast SSID

If you enable "Broadcast SSID", every wireless station located within

the coverage of this wireless router can discover this wireless router

easily. If you are building a public wireless network, enabling this feature

is recommended. Disabling "Broadcast SSID" can be more safe.

Associated Client

Click "Show Active Clients" button, then an "Active Wireless Client

Table" will pop up. You can see the status of all active wireless stations

that are connecting to the access point.

* Please click on the Apply Changes button or the Reset button at the bottom to save/reset the configurations.

1. Multiple APs

This is the window that pops up after clicking the button.

Click “Enable” to activate this AP, and then click the button “Show”, “Active Wireless Client Table –

AP1” window pops up as the following: