User's Manual
Table Of Contents
- Unpacking Information
- Chapter 1 Introduction to Wireless Router
- Chapter 2 Installing and Using Wireless Router
- Chapter 3 Management
- Appendix A: Product Specifications
- Appendix B: Glossary
Wireless 11n 2T2R Router
33
3.6 TCP/IP Settings
3.6.1 LAN Interface Setup
To set up the configuration of LAN interface, private IP of your router LAN port and subnet mask
for your LAN segment.
Items Information
IP Address
The IP of your Router LAN port (default 192.168.1.1).
Subnet Mask
Subnet Mask of you LAN (default 255.255.255.0). All devices on the
network must have the same subnet mask to communicate on the
network.
Default Gateway
Enter the IP Address of the router in your network.
DHCP
DHCP stands for Dynamic Host Configuration Protocol. It is a
protocol for assigning dynamic IP addresses “automatically.” You can
select to use this router as a DHCP client or DHCP server. To give
your LAN client an IP, you have to enable “DHCP Server”. If not,
manual setting up your client IP is necessary when you want to use
the router as your client’s default gateway.