Install Instructions

SRU Installation
2-2 SRU Inst allat ion Manual 17286-1000 Rev. B 03/14/01
To prevent any damage to the components, carefully unpack the units on a flat, clean
surface at the installation site. If a component must be unpacked at another location,
carefully repack it in the original container before moving it to the installation site.
Inspect components carefully for any damage. Damaged equipment should be reported
immediately to Netro and the shipping provider.
2.2 .1
2.2 .12.2 .1
2.2 .1 Subscriber Radio Compone nt
Subscriber Radio Compone ntSubscriber Radio Compone nt
Subscriber Radio Compone nt
The SRU is installed outdoors and mounted to a pole. One pole mount fixture design
(Mounting Plate, Strap and related hardware) serves the 10 GHz, 26 GHz, 28 GHz, and 39
GHz SRUs.
When installing non-integral antenna units, see section 2.4 for installation requirements.
2.2 .1.1
2.2 .1.12.2 .1.1
2.2 .1.1 Outdoor Compone nt s for SRU w ith Int e gral Antenna
Outdoor Compone nt s for SRU w ith Int e gral AntennaOutdoor Compone nt s for SRU w ith Int e gral Antenna
Outdoor Compone nt s for SRU w ith Int e gral Antenna
In addition to the SRU, the following parts are required for installation of the outdoor
equipment for SRUs with integral antennas. (See section 2.4 for non-integral antenna.)

Pole Mount Kit

The Pole Mount adapter is used to attach the SRU Mount to a pole. A single pole
mount design serves 26 G Hz, 28 G Hz, 39 G Hz, and 10 G Hz SRUs. The pole mount
is available as a stand-alone assembly and is available in combination with the SRU
mount (see the “Mounting Accessories” section of the Product Catalog). All bolts,
nuts, and washers are A4 stainless steel, which may be purchased locally. The Pole
Mount Kit includes:
• Mounting plate
• Strap
• M10 nuts, bolts, washers and anti-seize compound

SRU Mount

26 GHz, 28 GHz, and 39 GHz SRUs share the same SRU mount. See section 2.3.3
for illustrations.

A different SRU mount is required for 10 GHz SRUs. See section 2.3.6 for
illustrations.

SRU Installation Kit

The installation kit includes:
• TNC male 50 Ohm connectors for LMR240
• N-Type Female 50 Ohm connector for LMR400
• 1.5m length of LMR240 cable
• Self-amalgamating weather proof tape
• Extra jam nut for the grounding lug

In addition, the 10 GHz SRU installation kit also includes: