User's Manual

User manual
Black
DC-
GND
Yellow
ACC
ACC
Red
12V-OUT
12V output
Wiring: red and black wire are connected directly to the car battery. Red wire to positive, black
to negative. Yellow line contacts FireWire, ignition switch mode is set to mode. The DVR device
turns on when the vehicle power on,DVR turn off automatically the vehicle power off. Yellow
line connected to the car keys to open the position (that is, before the automobile starter motor
gear) all the dashboard lights.
Note: 1) Before connecting wires,one need to make sure the battery voltage is between 6V ~
36VUU, otherwise it will be burned;
2) After connecting the cable, pay attention to insulation of the line between lines to
prevent short circuit and burned out the battery;
3) yellow line must be connected to the firing line, otherwise the device will not
support the ignition switch;
4) Special Note: 12V-OUT line can not be connected to the power input by mistake,
which can not be connected to ground by mistake;
5) Note: DVR installation must be connected to battery positive and negative
directly, can not be done with ground grounding, grounding will produce negative glitch host
running. Positive and negative power supply line diameter must be Φ1.5 above.