Reference Guide

WAN and System Configuration 8-13
6. Select IP Profile Parameters and press Return. The IP Profile Parameters screen appears.
7. Toggle or enter any IP Parameters you require and return to the Add Connection Profile screen by pressing
Escape. For more information, see “IP Setup” on page 10-1 and “Multiple Network Address Translation
(MultiNAT)” on page 11-1.
Note: The NAT Map List Easy-PAT List and NAT Server List Easy-Servers are the defaults and should be left
unchanged unless they have been deliberately modified.
8. If you will be connecting with an IPX remote network, toggle IPX Enabled to Yes and press Return.
Otherwise, accept the default No.
If you enable IPX routing, an IPX Profile Parameters menu item becomes available. Select IPX Profile
Parameters and press Return. The IPX Profile Parameters screen appears.
IP Profile Parameters
Address Translation Enabled: Yes
IP Addressing... Numbered
NAT Map List... Easy-PAT List
NAT Server List... Easy-Servers
Local WAN IP Address: 0.0.0.0
Local WAN IP Mask: 0.0.0.0
Remote IP Address: 0.0.0.0
Remote IP Mask: 0.0.0.0
Filter Set...
Remove Filter Set
RIP Profile Options...
Configure IP requirements for a remote network connection here.