Reference Guide

AppleTalk Setup 13-7
AppleTalk nodes will appear. If you do not set a default zone, the first zone you create will be the default
zone.
■ You can also set the range of EtherTalk Phase II network numbers. Select Net Low and enter the lower limit
of the network number range. Select Net High and enter the upper limit of the range.
■ Select the Seeding pop-up menu and choose the seeding method for the Netopia R6000 Series to use.
(See “Routers and seeding” on page 13-3).
You have finished configuring EtherTalk Phase II.
LocalTalk setup
For instructions on making the physical connections for LocalTalk, see “Connecting to a LocalTalk network” on
page 4-5.
In the AppleTalk Setup screen, select LocalTalk Setup and press Return. The LocalTalk Setup screen appears.
■ If you are using LocalTalk with the Netopia R6000 Series, select LocalTalk Enabled and make sure
LocalTalk is set to On, which is the default.
Note: Since the LocalTalk connector attaches to the Auxiliary port on the router, that port will no longer be
available for an external modem.
■ Select LocalTalk Zone Name and enter a new or existing zone name.
Note: Your LocalTalk network may already have a zone and network number in place. For the Netopia
R6000 Series’s LocalTalk port to be part of your LocalTalk network, it must have a network number and
zone name that matches the values in use on the LocalTalk network.
LocalTalk Setup
LocalTalk Enabled: On
LocalTalk Zone Name: Unnamed
LocalTalk Net Number: 33126
Seeding... Soft-Seeding
Use this screen to set up the LocalTalk Port Routing attributes.