User Manual

www.netogy.co.za
Copyright © Nology (Pty) Ltd | E&OE
Device Support: [phone]
Operating Hours: 08:00 – 17:00 (Mon – Thurs)
08:00 – 16:00 (Fri)
Device Support Information
WARNING
1. Always check the working voltage, current and polarity of the loads before
connecting them to the UPS, connecting them to the appropriate voltage
output.
2. Charge device fully prior to initial use.
3. Damage caused by dropping, disassembling or attempting to repair the UPS
privately will render your warranty null and void.
4. Do not immerse the UPS in water or allow it to get wet.
5. Do not dispose of any of the UPS’s components in a re.
6. Do not use the UPS in a ammable environment.
7. Keep the UPS out of reach of children and unauthorised persons.
The total power of the loads which connect to all the ports cannot exceed the
maximum output power of your model. If this does occur, the USB ports will be
disabled and the status light will ash yellow. If the total power of the loads still
exceeds the maximum power rating after the USB ports are disabled, then all
the output ports will be turned off, and all power indicator lights will ash. In this
situation, please remove excess load.
If the UPS will not be used for extended periods, ensure that it is fully charged
before storing in a cool, dry place. If the UPS has been in storage too long, you will
need to plug in mains power until the status light turns green. It is recommended
that the UPS battery is charged once per month.
IMPORTANT