MINI 14400mAh DC UPS / POWER BANK UPS100-PLUS USER MANUAL Thank you for choosing our UPS. Before operating this unit, please read the USER MANUAL carefully to ensure that the best possible performance is obtained.
1. Box Content 1 x Multi-output power backup mini UPS unit 1 x Straight cable 2.5mm Male to Male (1m) 1 x AC power cable 1 x Y cable 2.5mm Male to Male (50cm) 2 x Adapters (2.5mm Female to 2.1mm Male) 1 x User Manual 2.
BACK 19V 5A Output 9V / 12V 9V / 12V DC 3A Output Voltage Switch 12V / 5A AC Output Input 3. Features • • • • • • • • Emergency uninterruptible power supply - perfect for load shedding. Can be used as a Power Bank. High output power (100W) - capable of powering multiple devices simultaneously. Suitable for most digital devices with 8 x DC outputs supporting multiple voltages and 2 x 5V USB ports. High-capacity (14400mAh hours) Lithium Iron Phosphate (LiFePO4) battery.
• • to connect to the UPS for connection/setup to the UPS – the UPS will power the connected devices. ONLY connect 2 devices to the Y-Cable if they have the same voltage rating and they are close enough to each other for the 2 ends of the Y-cable to reach both devices.
STEP 3: Switching the UPS on Switch the UPS100-PLUS on by pressing and holding the ON/OFF power button for 2 to 3 seconds on the UPS. ON/OFF power button 5.
. LED Explanation LED Status Description Green AC/Mains power on Yellow Maximum Output power exceeded - USB ports disabled Red AC/Mains power off - using battery 12V Green Selector switch is set to 12V and a device is connected to the Yellow 9V/12V Output 9V Green Selector switch is set to 9V and a device is connected to the Yellow 9V/12V Output 25 Flashing Very low battery level 25 Battery Capacity LEDs 25% battery level indicator 25 50 50% battery level indicator 25 50 75 25 50
Physical 253 x 146 x 45mm 0.7kg Unit Dimension (mm) Net Weight (Kg) Environment 0° - 40° C 20% - 90% Less than 40dB Operating Temperature Humidity Noise Level * * Product specifications are subject to change without notice. To ensure the safety of transportation, the battery is not fully charged when leaving the factory. Please charge before use. 8. Troubleshooting Issue / Error Possible Explanation/Solution Status LED is RED This is not an error or issue.
IMPORTANT The total power of the loads which connect to all the ports cannot exceed the maximum output power of your model. If this does occur, the USB ports will be disabled and the status light will flash yellow. If the total power of the loads still exceeds the maximum power rating after the USB ports are disabled, then all the output ports will be turned off, and all power indicator lights will flash. In this situation, please remove excess load.
