User's Manual

ManualsBrandsNETIS SYSTEMS ManualsElectronicsWireless Dual Band Router

Table Of Contents

Package Contents

System Requirement

● Windows 8 Windows 7 ● Windows Vista

● Windows XP ● Windows 2000

●

1. Connect the WAN port on your router to the Modem's LAN port with an Ethernet cable

2. Connect your computer to any LAN port on netis router with an Ethernet cable

3. Plug in the power adapter of netis router

4. Unplug your ADSL or Cable Modem power at least 15 seconds and plug it back in

1.Hardware Connection

POWER

CABLE

LINE IN

CABLE

POWE R

Modem

*This QIG is shared by netis wireless dual band router

Set the IP address of your wired network adapter as

Automatically as showing below

(Turn over)

WF2471

Wireless Dual Band Router

Quick Installation Guide

Connecting by netis one stop setup

Connection

IPV4 Connectivity:

IPV6 Connectivity:

Media State:

Duration:

Speed:

Internet

No Internet access

Enabled

00:39:39

100.0Mbps

Details. ..

Activity

Sent Received

10,000,680 80,000,680

Status

General

Byes:

Disable

Diagnose

QIG

Power Adapter

Wireless dual band router

N60 0 Wirel ess

Dua l Band( Gigab it) Rou ter

Qui ck Inst allat ion Gui de

Ethernet Cable

Open your browser and type 192.168.1.1

in the address field

http://192.168.1.1

tip.Most internet connectio type is DHCP as l ong a s

you don`t have ID/Password for connection Internet.

One stop setup!

The most convenient nets`AP Router configuration!

Internet Connection Type

Wiress Setup

SSID:

Password:

2.4GHz

5GHz

Pass word

tip. pl eas e en ter any 8 -63 cha rc ters

Advanced

Internet

Wiress

Save

Tips 1: If you are connecting to a Broadband service

that uses a dynamic connection (DHCP), you may

be online already. Try opening a web browser and

enter a web site. If you connect to a web site, you

are fnished with your Internet setup.

Select the Internet Connection Type you

use. We take DHCP for example. Configure

your Wireless Setup such as SSID Password

then click save to make setting effective. The

connection status page will appear below

connection sucessfully. you had been online!

Tips 2: you would click

to go to advance setting page.

Advanced

pass word

neti s_2_4 G

DHCP(Cable Mode m) Static IP PPPoE

Enable Disable

Summary of content (2 pages)

PAGE 1
.Hardware Connection Package Contents *This QIG is shared by netis wireless dual band router Modem WF2471 POWER Wireless Dual Band Router Quick Installation Guide Wireless dual band router Power Adapter POWER N600 Wireless Dual Band(Gigabit) Router Quick Installation Guide LINE IN Ethernet Cable QIG CABLE CABLE 1. Connect the WAN port on your router to the Modem's LAN port with an Ethernet cable 2. Connect your computer to any LAN port on netis router with an Ethernet cable 3.
PAGE 2
3.Troubleshooting Q How do I restore my Router's con guration to its factory default settings? A With the Router powered on, press and hold the Default button on the rear panel for 8 to 10 seconds using a pin before releasing it. What can I do if I cannot access the Internet? 1) Check to see if all the connectors are connected well, including the telephone line (for your modem), Ethernet cables and power adapter. 2) Check to see if you can access the Router's web manage- ment page.