User's Manual

150Mbps Wireless-NHigh Gain Broadband Router User Manual
61
have another connection type (like static User),you will need to click on “Quick Setup” in
the menu and input information given you by your service provider and then click save .
WDS:If you are using this router to spread the wireless coverage of another router,or to
spread the coverage to another router,you can use WDS mode.
 You can co
AP+WDS:You can bridge two LAN or two computers via two AP, the wireless signal
will be amplified and transmitted at the same time.
nfigure the rout
erfollowing the steps in 4.5.4.
 You c
Client: In this mode，the router function is approximately equal to a wireless adapter，you
can make a wireless connection to the internet.
an configure the rout
er following the steps in 4.5.4.
 Attach one en
d of an Ethernet cable to your computer’s port,and the other end to one of the
LAN ports of your router.
 Configure Your Computer
 Select “wireless”-“wireless settings”, select the client mode, click on “AP scan” and you
will see a new window options, select the AP you want to connect to, and click the
“connect” button below.
 If your AP is notencrypted, click “save” and reboot the router.
 If your AP is encrypted, select “wireless security” and input the key in this interface, then
ve” and reboot the router. click on “sa
Repeater: In this mode, it’s an electronic device that amplifies a signal before
transmitting it again; it can be used in computer networks to extend transmitting distances.
 Attach one end of an Ethernet cable to your computer’s port,and the other end to one of the
LAN ports of your router.
 Configure Your Computer according to the QIG
 Select “wireless”-“wireless settings”, select the repeater mode, input the Repeater
SSID,then click the “AP Scan”and you will see a new window options, select the AP you
want to connect to, and click the “connect” button below.