User's Manual

6.5. WDS Settings
If you have selected WDS or AP+WDS mode in Wireless Basic-Radio Mode, please do the
following configurations.
Figure 6-8
 WDS Name: Give a description of your wireless bridge to tell apart.
 WDS MAC Address: If the current working mode is “WDS” or “AP+WDS”, then you need
to configure wireless bridge configuration. Enter MAC address of remote access point, at the
same time the remote access point also need to configure to “WDS” or ”AP+WDS” mode.
 Current WDS Information: It illustrates basic information of all wireless bridge that in
connection status, you may delete unnecessary bridge.
AP1:
 Select radio mode is WDS or AP+WDS in wireless management-basic of AP1.
 Click on ‘Wireless Management’- ‘AP Setup’- ‘Security’ and select and save None as
authentication type.
 Click on ‘Wireless Management’- ‘AP Setup’- ‘Security’ and select and save None as WDS
authentication type or select a WDS security type, enter key and save.
 Input WDS name (e.g.: default), input MAC address of AP2 (00-22-4f-bc-af-5d), click add,
then the record named default will appears in WDS list.
 Select Channel is ‘Channel 6’in wireless management-basic of AP2.
AP2:
 Select radio mode is WDS or AP+WDS in wireless management-basic of AP2.
 The IP address of AP2 should be 192.168.1.x (1<x<255,e.g.: x=8).
 Select ‘LAN setup’-‘DHCP server’ ,select disable DHCP server.
 4. Input WDS name (e.g.: Default), input MAC address of AP1 (00-22-4f-cc-ae-f5), click add,
then the record named Default will appears in WDS list.
 Select Channel is ‘Channel 6’in wireless management-basic of AP2.
Note: Before you setup WDS connection, please make sure that AP1 and AP2 is in the same
network, that is if the IP address of AP1 is 192.168.1.1, then the IP address of AP2 should be