User Manual

5 Antenna
2.3. Hardware Installation Procedures
The procedures to install the NW725P please refer to Figure 2-3
Figure 2-3
¾ Step 1 connecting your computer to the LAN port.
Attach one end of the Ethernet cable with RJ-45 connector to your hub, switch or a computer’s
Ethernet port, and the other end to one of the LAN ports of your NW725P.
¾ Step 2 Connecting Cable/ADSL Modem to the WAN port.
Connect the Ethernet cable attaching to your Cable/ADSL modem to the WAN port of your
NW725P.
¾ Step 3 connecting the power adapter.
Connect the single DC output connector of the power adapter to the power jack on the side of
the NW725P. Then plug the Power Adapter into an AC outlet.
¾ Step 4 Power on the following devices in this order:
Cable/ADSL modem, Router, and PCs